.png?width=150&height=65&name=logo_tyto_robotics_2000_860%20(1).png){kind=logo}
Software
- My servo motor does not move at all when I try to control it.
- Can I use the automatic script to control servo motors?
- Your computer does not find the driver automatically
- Can't Balance Propellers / Can't Achieve a Passing Grade
- WindShaper Not Detected by Flight Stand Software
- Negative Torque Value
- Device Stuck in Bootloader
- Measurements Did Not Start at 0
- Issue Connecting Hardware Devices
Crash
WindShape
Flight Stand
RC Benchmark: Series 1585
- I had a vibration cut-off on my Series 1585.
- Can I make an automatic control script with a given RPM or thrust input?
- Can I stream my measurement data to any 3rd-party softwares such as Matlab, ROS, Raspberry Pi?
- Can I use another PC for the same stand without redoing the calibration or first-time setup? Can I migrate the data to another computer?
- I observed fluctuating sampling rate in my CSV file.
- I observed missing measurements in my CSV file.
- Can I use ChromeOS to control the stand?
- RCbenchmark Software Tutorial
- I do not have any Electrical RPM reading
- I have a wrong reading on the Electrical RPM Probe
- Where can I find setup instructions of the Electrical RPM sensor?
- I find the RPM reading is fluctuating during the test
- The RPM reading seems wrong
- There is no reading on the optical RPM probe
- I think I have the wrong thrust/torque reading
- My calibration did not pass
- I cannot connect the circuit to the PC
- I cannot flash the firmware
- What is the accelerometer orientation?
- How to get the vibration value?